- GENIUS G540 DEVICE PROGRAMMER TESTER SERIAL
- GENIUS G540 DEVICE PROGRAMMER TESTER DRIVERS
- GENIUS G540 DEVICE PROGRAMMER TESTER PLUS
SIMM sockets in the left front quadrant ('front' referenced to the front of the Terms of visual inspection, by the fact that it does not have a pair of 30-pin Memory expansion board to go beyond 1MB RAM. The early revision, as present in programmers with revisionĬodes -001 through - 011, did not support the hard drive option and required the You must be in terminal mode to see test results, not Tasklink.ĭata I/O used two revisions of logic boards in Usually do a quick test of any Data I/O with my terminal just to see if it boots
GENIUS G540 DEVICE PROGRAMMER TESTER SERIAL
Pin 3 wire cable for serial and the HP parallel cable for the high speed port. Will go out after the self test without a boot disk. If the unit has a internal hard disk then the the self test light If the unit does not have a hard disk then aįloppy boot disk is required to complete the start-up and the self test light
GENIUS G540 DEVICE PROGRAMMER TESTER PLUS
Modules plus the Site 48 and PinSite adapter the self-test takes about 5 Without the 17 PinSite modules and no adapters installed the self-test is about 10 seconds.Īs you add PinSite modules the self-test takes longer. If the unit has a MSM the light should go out in a couple minutes. WRONG!! If it does not go out there may be a problem, if they did not haveĪ boot disk in the drive then the self-test cannot continue and the light stays Say in the auction the Self-Test passes because the light stays on, Work, usually the seller knows nothing about it so they say for parts only. These units are frequently on eBay and may There can be from 1 to 17 depending on your needs. PinSite modules used with the PinSite adapter. Old Style main board with memory soldered onto board, lower left. Older style UniSite, no MSM only memory expansion. PPI adapter for use with UniSite PinSite module. Individual SOIC modules available, all 7 of them. Individual PLCC modules available, all 7 of them. PinSite modulle is used with the PLCC, SOIC, PPI etc. The pencil points to the cable pugged into the disk connector on newer boards and memory exp.
Main board removed showing the dual floppies and the hard disk module. This ia also they way it would look without the PinSite option. I have seen this missing on many UniSites with these modules.Īll PinSite modules removed. You can see the power on light in the upper right and the ready in the lower left.īack side showing the nylon space adapter to stabilize the PinSites.
The self-test will turn off within a few seconds to several min. This is my UniSite backup programmer, it also has a MSM, no parallel port. UniSite Xpi-68 back showing the addition of the HP type parallel port. The communication setup using the remote connector. UniSite system disagnostic test showing all systems have passed including the MSM.
GENIUS G540 DEVICE PROGRAMMER TESTER DRIVERS
UniSite terminal showing version 8.4, 8 megs of ram and 68 pin drivers